Bluff continues to move at San Clemente railroad site

An excavator sits parked next to a section of railroad tracks where work is being done to repair a recurring landslide.
An excavator sits parked next to a section of railroad tracks where work is being done to repair a recurring landslide that has suspended passenger train service.
(Hayne Palmour IV/For The San Diego Union-Tribune)

Workers to begin installing anchors in slope this weekend, repairs expected to continue through the end of this year


Excavation is expected to start Friday for the installation of ground anchors to stop the still-sliding slope beneath the railroad tracks at San Clemente, an Orange County Transportation Authority spokesman said this week.

Metrolink and Amtrak suspended passenger rail service Sept. 30 between San Diego and Orange Counties after movement was detected in the area of an old landslide just north of the San Diego County border. The service suspension is expected to continue through the end of the year while repairs are underway.

For the record:

5:17 p.m. Nov. 11, 2022An earlier version of this story had an incorrect year for when a previous slide was discovered at San Clemente. The previous slide was seen in September 2021.

“Very slight incremental movement is still being recorded daily,” OCTA spokesman Eric Carpenter said Wednesday, although the rainfall early in the week did not appear to affect the slide.

BNSF freight trains continue to operate through the repair area, although with reduced frequency and speeds, officials said.

The 140-year-old coastal rail line is the only viable route for passenger and freight trains between San Diego and the rest of the United States. The 350-mile line between San Diego, Los Angeles and San Luis Obispo, known as the LOSSAN corridor, is one of the nation’s busiest rail routes.

The tracks move laterally at a rate of fractions of an inch daily as measured by inclinometers placed in the ground at the San Clemente slide. A total of about 28 inches of movement has been detected since motion was first discovered in September 2021.

Passenger service was suspended for about two weeks at the time, while construction workers added 18,000 tons of boulders to the beach revetment that holds back the slope and moved the tracks back to their original location. That work stopped the slide until new movement was detected after rains in September of this year.

OCTA approved a contract in October with the Condon-Johnson company to install the anchors that are intended to stop the slide.

“Clearing of vegetation and any other debris in the construction area has been completed,” Carpenter said. The next step is to install the anchors, which are large flat plates held by steel cable anchors drilled into the bedrock.